Refrigerators seals

We can supply you with thermal insulation seals for refrigerator doors to retain cold inside the refrigerator and freezer compartments of domestic and commercial refrigeration equipment.

Black refrigerator seal White refrigerator seal
How to measure refrigerator seals correctly Various types of refrigerator seals are available on Dostavka.net.ua.

To order, it is advisable to determine what type of seal mount is installed on your refrigerator:

"Narrow collar 20 mm (universal)"

Universal refrigerator sealing

The profile is glued or screwed along the perimeter of the door (Nord, Dnepr, old Stinol/Snaige/Minsk/Atlant/Ardo, Liebherr and some others)

“Under the bar”:

a) The seal is glued (originally at the factory) between the door and the plastic panel (strip) of the refrigerator door using mounting foam - new refrigerators Stinol, Indesit, etc.

Refrigerator sealing under bar

Here are step-by-step instructions for installing seals on Indesit/Stinol and Ardo refrigerators

b) The seal is screwed on with self-tapping screws (as in the photo) through the plastic inner door panel (bar) - refrigerators Polyus, Biryusa, new Nord, Stinol, Dnepr, Minsk, Pentan, etc.

How to choose a refrigerator seal

When bending the profile to the left or right, the seal will bend only in one direction, since it is tucked with its “tail” (collar) under the strip and glued or screwed in with self-tapping screws.

The height and width of the sealing frame are measured along the outer contour of the seal.

“In the groove”:

Groove-type refrigerator seal How to choose a groove-type refrigerator seal

It is inserted into the mounting groove located along the entire perimeter of the door.

When bending the profile to the left or right, the seal will bend evenly (equally) in both directions, since the “arrow” of the seal protrusion is usually located in the center (sometimes shifted to the side) of the seal.

If you have already found your seal in our catalog of seals , place an order on the website, we will call you / write / agree on the details and send the order

If you need help choosing a gasket, please prepare a photo of the refrigerator nameplate, the dimensions of the gasket along the outer edge, and show them on Viber/Telegram/WhatsApp in the contacts section.

In most cases, our seal is attached to the door with glue, tape or screws, clamped with strips or inserted into the door groove.

Installing the seal

1. Profile for gluing:

  • After unpacking our parcel, lay the seal on the floor and wait until it levels out!
    - Remove the door and lay it horizontally. Prepare a flat surface 3-5 cm wide around the entire perimeter of the door (remove the old seal and clean off any remaining debris).
    - place the seal around the perimeter of the door where it should be, away from the door hinges
    - fasten the seal (with the fastening collar, not the magnetic side!) to the perimeter plane of the door (or behind the door panel) with glue or self-tapping screws (depending on the type of fastening you have)
    - when installing the door, adjust the even fit of the door to the refrigerator body using the bolts on the hinges

Here are step-by-step instructions for installing seals on Indesit/Stinol and Ardo refrigerators

2. Profile for insertion into the door groove:

- first insert the sealant only at the corners, then press it into the centers, then between them, and so on, leveling it evenly